Production Technology Mcqs

Q.  The reasons which are basically responsible for the formation of a queue should be that ___________________?

a. the average service rate Hess than the average arrival rate
b. output rate is linearly proportional to input
c. output rate is constant and the input varies in a random manner
d. all of the above
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  A file removes the metal during___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a _____________ , both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A neutral flame is obtained by supplying___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The cold working of metals is carried out_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Lancing is the operation of _________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In spot welding, the spacing between two spot weld should not be less than _______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shrinkage allowance for cast iron pattern is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Tandem drawing of wires and tubes is necessary because_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The operation of straightening a curved sheet metal, is known as____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statement is wrong ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following cycles uses air as the refrigerant__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The relative coefficient of performance is_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Clapeyron equation is applicable for registration at___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapor compression cycle, the condition of refrigerant is very wet vapor________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A refrigerant should have _____________________? Pick up the wrong statement ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Clapeyron equation is a relation between___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapor compression cycle, the condition of refrigerant is high pressure saturated liquid________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The boiling point of ammonia is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In S.J. unit, one ton of refrigeration is equal to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Allowable pressure on high-pressure side or ammonia absorption system is of the order of_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts