Design of Concrete Structures Mcqs


Q.  The purpose of reinforcement in prestressed concrete is________________?

a. to provide adequate bond stress
b. to resist tensile stresses
c. to impart initial compressive stress in concrete
d. all of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Removal of props under______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The spans of filler joists supporting a slab may be considered approximately equal if the longest span does not exceed the shortest span more than__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  All reinforcement should be free from_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The permissible bending stresses Pbet for steel slab bases should not exceed_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Pick up the correct statement from the following?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The anchorage value of standard U-type hook of a reinforcing bar of diameter d in tension, is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Pick up the correct statement for the web stiffeners?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Moist sand may contain surface water by mass upto__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A fully saturated soil is said to be________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Water content of soil can______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Constant head permeameter is used to test permeability of_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the voids of a soil mass are full of air only, the soil is termed as_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Voids ratio of a soil mass can_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following types of soil is transported by gravitational forces ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Residual soils are formed by______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Valid range for n, the percentage voids, is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Valid range for S, the degree of saturation of soil in percentage is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  When the degree of saturation is zero, the soil mass under consideration represents______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Select the correct range of density index,ID ________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the volume of voids is equal to the volume of solids in a soil mass, then the values of porosity and voids ratio respectively are________________?
Category: Civil Engineering Mcqs,   Published by: teswesm