MCQs: Digital to Analog Conversion is ______________ Analog to Digital Conversion.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Micro-controllers are ________________ than the PLCs.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: How is the noise immunity of PLCs to electrical noises as compared to that of conventional relay controllers?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The capability of convention relay systems for complex operations is ___________ that of the PLCs .
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: How is the speed of operation of conventional relay system as compared to digital controllers?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The type of memory which is fast and temporarily stores the data which are immediately required for use is called as______.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: When ___________ contacts are actuated, they disrupt the power supply through them.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which method is used for stability analysis?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: What is the ratio of amplitude of response to that of the input called?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In all cases of input frequency, if the gain starts reducing, the phase angle will _______.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If the frequency of the input signal to a system is increased, the amplitude of the output _______.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: __________ is the time required for the response to reach 50% of the final value in the first attempt.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following is/are the drawback/s of proportional control? 1. Proportional control system is complicated and costly. 2. Proportional control system is not suitable for pressure temperature and flow control problems 3. If there are sudden disturbance, the proportional control system takes time to stabilize.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Shifting of set point and adjusting its new value by the controller, when the value of disturbance increases, is called as_______.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The range of control of controller __________ due to presence of offset.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If the value of error increases, the changing speed of controller output __________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The product of force (F) and time (t) is called as________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: What is the formula for forces exerted by fluid on a body?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The radial force in rotodynamic machine, which is developed by rate of change of momentum in radial velocity, is taken care by__________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Meridonial velocity is the resultant of _____________ components of fluid velocity.
Category: Mechanical Engineering Questions, Published by: teswesm
|