Design of Concrete Structures Mcqs


Q.  The permissible diagonal tensile stress in reinforced brick work is_____________?

a. about 0.1 N/mm2
b. zero
c. 0.3 N/mm2 to 0.7 N/mm2
d. about 1.0 N/mm2


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  A T-shaped retaining wall mainly conssits of_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  To minimise the effect of differential settlement, the area of a footing should be designed for______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In a pile of length /, the points of suspension from ends for lifting it are located at______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  While designing the pile as a column, the end conditions are nearly_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The critical section for finding maximum bending moment for footing under masonry wall is located_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the foundations of all the columns of a structure are designed on the total live and dead load basis, then_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  During erection, the pile of length / is supported by a crane at a distance of________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  According to ISI recommendations, the maximum depth of stress block for balanced section of a beam of effective depth d is__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The centroid of compressive force, from the extreme compression fiber, in limit state design lies at a distance of__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The load factors for live load and dead load are taken respectively as_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  According to Whitney’s theory, ultimate strain of concrete is assumed to be_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Assertion A : The load factor for live load is greater than that for dead load. Reason R : The live loads are more uncertain than dead loads? Select your answer based on the coding system given below :
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The design yield stress of steel according to IS: 456-1978 is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  According to Whitney’s theory, depth of stress block for a balanced section of a concrete beam is limited to_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  As per Whitney’s theory, the maximum moment of resistance of the balanced section of a beam of width b and effective depth d is given by_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Due to shrinkage stresses, a simply supported beam having reinforcement only at bottom tends to_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A beam curved in plan is designed for_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In a spherical dome the hoop stress due to a concentrated load at crown is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In prestressed concrete______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Normally prestressing wires are arranged in the_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm