Process Equipment & Plant Design Mcqs for Chemical

Q.  The normal range of velocity of steam in pipes is _________________________ m/sec?

a. 0.1-0.5
b. 1-5
c. 10-20
d. 80-100


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  In case of design of a shell and tube heat exchanger___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Cylindrical pressure vessels in horizontal condition is generally supported on a ________________ support?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pick out the wrong statement pertaining to the comparative evaluation of performance of the packed tower and the plate tower ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Flanges are connected to pipes by _______________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the downcomer of a distillation column, the minimum recommended residence time is about _______________ seconds?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum liquid gradient over a tray must not exceed__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a thin cylindrical shell, the hoop stress is ________________ stress?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pressure drop per tray in the atmospheric distillation column is about ________________ psi?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  n the agitators, the power required will be changed with the increase of diameter of agitator D. as ____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pick out the correct statement___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The circumferential (hoop) stress in a thin walled cylindrical vessel under internal pressure is______________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Vertical condenser is advantageous to the horizontal condenser from operation point of view, when________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  An increase in the liquid resistance to interphase mass transfer and a resultant reduction in plate efficiency is caused by______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Overall tray efficiency of a distillation column is the ratio of the number of ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Fouling factor must be included in the calculation of overall design heat transfer coefficient, when the liquid__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is not a graphical method (but is an analytical method) for the calculation of theoretical number of stages in case of continuous binary distillation ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For storing hazardous chemicals in large storage tanks, the minimum safe distance between the two tanks should range between ______________________ times the tank diameter?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If a single tube pass heat exchanger is converted to two passes; for the same flow rate, the pressure drop per unit length in tube side will _____________ times?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Rivets are generally specified by the____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Shortest distance between two tubes is___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts