Stoichiometry Mcqs for Chemical

Q.  The molar composition of a gas is 10% H2, 10% O2, 30% CO2 and balance H2O. If 50% H2O condenses, the final mole percent of H2 in the gas on a dry basis will be_______________?

a. 10%
b. 5%
c. 18.18%
d. 20%


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Lenz’s law results from the law of conservation of___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following units is not present in both the vapor compression refrigeration system and absorption refrigeration system ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  One ton of refrigeration capacity is equivalent to the heat removal rate of____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Entropy, which is a measure of the disorder of a system, is__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A refrigerator works on the principle of _____________ law of thermodynamics?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Gibbs free energy (G) is represented by, G = H – TS, whereas Helmholtz free energy, A. is given by, A = E – TS. Which of the following is the Gibbs-Helmholtz equation ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pick out the correct statement?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A thermodynamic system is taken from state A to B along ACB and is brought back to A along BDA as shown below in the P-V diagram. The net work done during the complete cycle is given by the area covered by_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The equation relating E, P, V and T which is true for all substances under all conditions is given by (∂E/∂V)T = T(∂P/∂T)H – P. This equation is called the ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Cv is given by__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  There is a change in ______________ during the phase transition?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In Joule-Thomson porous plug experiment, the__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A gas mixture of three components is brought in contact with a dispersion of an organic phase in water. The degree of freedom of the system is______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A cyclic engine exchanges heat with two reservoirs maintained at 100 and 300°C respectively. The maximum work (in J) that can be obtained from 1000 J of heat extracted from the hot reservoir is_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Chemical potential (an intensive property) of a substance is a force that drives the chemical system to equilibrium and is equal to its partial molar properties. The ratio of chemical potential to free energy of a pure substance at constant temperature and pressure is________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  One mole of nitrogen at 8 bar and 600 K is contained in a piston-cylinder arrangement. It is brought to 1 bar isothermally against a resisting pressure of 1 bar. The work done (in Joules) by the gas is_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Trouton’s ratio of ______________ liquids is calculated using Kistyakowsky equation?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The shape of T-S diagram for Carnot Cycle is a__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Claude’s liquefaction process employs the cooling of gases by__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  “The rate at which a substance reacts is proportional to its active mass and the rate of a chemical reaction is proportional to the product of active masses of the reacting substances”. This is the_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts