Chemical Engineering Basics Mcqs


Q.  The minimum and the maximum number of members required to form a Private Limited Joint Stock Company are respectively __________________?

a. 7 and 30
b. 10 and 50
c. 2 and 50
d. 13 and 55


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Nickel and ______________ are the alloying element added in steel to increase its toughness?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The lightest non-inflammable gas is_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The surface tension of a liquid, at critical temperature is____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  ‘Amortization’ in respect of financial obligation of a company means the_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The same volume of all gases is representative of their_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The function of neutral flux used in the pyrometallurgy of metal extraction is to increase the _____________ of the slag ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  For infinite parallel planes having emissivities ε1 & ε2, the interchange factor for radiation from surface 1 to surface 2 is given by__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Wave length of X-rays is about 1 angstrom; however it cannot pass through a sheet of ________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is an unconventional source of energy ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of ______________ will facilitate the most accurate measurement of the temperature ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Silicon in steel__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Super heating of steam is done at constant___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Corrosion is____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following phenomenon will exhibit the minimum heat transfer ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following metals cannot be hot worked at room temperature ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following equipments is used for liquid dispersion ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Limestone is added in the blast furnace (during pig iron manufacture) to______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The boiling & freezing points on a newly defined temperature scale in degree ‘D’ are 400°D & 100°D respectively. The temperature reading corresponding to 60°C on this new temperature scale will be equal to _____________ °D ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Difference at any instant between the value of the controlled variable and the set point is called the__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Cementite is in the lamellar form in the _____________________ phase of steel ?
Category: Chemical Engineering Mcqs,   Published by: teswesm