Applied Mechanics & Graphic Statics Mcqs

Q.  The maximum pull in a cable, carrying a uniformly distributed load and supported at two ends which are at the same level, is at_____________________?

a. supports
b. quarter span
c. mid span
d. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  A stone is thrown up a slope of inclination 60° to the horizontal. At what angle to the slope must the stone be thrown so as to land as far as possible from the point of projection ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If a projectile is fired with an initial velocity of 10 m/sec at an angle of 60° to the horizontal, its horizontal and vertical velocity at the highest point of trajectory are___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A projectile has maximum range of 40 m on a horizontal plane. If angle of projection is a and the time of flight is 1 second, then sin a must be about__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum value of the horizontal range for a projectile projected with a velocity of 98 m/sec is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For a given velocity of a projectile, the range is maximum when the angle of projection is___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  When a circular wheel rolls on a straight track, then the shape of body centrode and space centrode respectively are________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The angular speed of a car while taking a circular turn of radius 100m at 36 km/hour, is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The ratio of the speed of a rolling cylinder to the speed of sliding cylinder is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A flywheel of moment of inertia 20 kg-m” is acted upon by a tangential force of 5 N at 2 m from its axis, for 3 seconds. The increase in angular velocity in radian persecond is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A circular disc rotates at n rpm. The angular velocity of a circular ring of same mass and radius as the disc and to have the same angular momentum is___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Rate of change of angular momentum is equal to_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A solid sphere of mass M and radius R rolls down a plane inclined at 0 with the horizontal. The acceleration of sphere is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A hoop of radius 3 m weighs 100 kg. It rolls along a horizontal floor so that at its centre of mass has a speed of 200 mm/sec, . The work required to stop the hoop is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The total kinetic energy of a hoop of mass 2 kg and radius 4 m sliding with linear velocity 8 m/sec and angular velocity 5 radian/sec is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum potential energy of a system will be in the position of________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A block in the shape of a parallelopiped of sides lm x 2m x 3m lies on the surface. Which of the faces gives maximum stable block ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A cube on a smooth horizontal surface___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  When two forces, each equal to P, act at 90° to each other, then the resultant will be_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A rod AB carries three loads of 30 N, 70 N and 100 N at distances of 20 mm, 90 mm and 150 mm respectively from A. Neglecting the weight of the rod, the point at which the rod will balance is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The unit of power in S.I. units is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts