Turbo Machines Test Questions

Q.  The mass flow rate of air compressed in axial flow compressor is _____________centrifugal compressor.

a. lower than
b. higher than
c. same as
d. unpredictable


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which pump is more suitable for an application where very high pressure is required to be developed at moderate discharge?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The process of filling the liquid into the suction pipe and pump casing upto the level of delivery valve is called as _________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The volute pumps and vortex volute pumps are __________ pumps with _________ shaft.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following centrifugal pumps has higher specific speed than the others?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Angular momentum of gas in the free vortex of vaneless diffuser ___________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Vaneless diffusers are suitable for ___________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The diffuser blades are kept ______ the number of impeller blades .
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ratio of actual whirl velocity to the ideal whirl velocity in the centrifugal compressor is called as _________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the ratio of isentropic work to Euler work in an centrifugal compressor called?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  ___________ can be defined as the ratio of the pressure rise in rotor blades to the pressure rise in stages in an axial flow compressor.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the ratio of the actual work absorbed by an axial flow compressor to the theoretical work called?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the effect of increasing flow coefficient (Φ) in an axial flow compressor on blade loading coefficient (Ψ)?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which equation is used to calculate thickness of an alloy steel cylinder with open ends?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Why is autofrettage process used in pressure vessels?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Due to which effect, compressive residual stress of strain-hardening model is smaller than elastic-perfectly plastic model?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Claviro's equation is applicable to cylinders with _______
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which equation is used to determine wall thickness for brittle materials?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the weld joint efficiency if pressure vessel is fabricated with single full fillet lap joint?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is not an unfired pressure vessel?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In unfired pressure vessels, category A consists of _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts