Strength of Materials Test Questions


Q.  The graphical method of Mohr's circle represents shear stress (τ) on ______

a. X-axis
b. Y-axis
c. Z-axis
d. None of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Modulus of resilience is the ratio of ______
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  What is the strain energy stored in a cube of 50 mm, when it is subjected to shear stress of 200 Mpa. (G = 100 Gpa)
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Energy stored in a body within an elastic limit is called as _____
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A member subjected to couple produces rotational motion about its longitudinal axis called as ________
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following assumptions are made in torsion theory?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  While determining crippling load, the effective length of solid circular bar is 1/ √2 of actual length if, _______
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Rankine-Gordon's empirical formula is applicable for _____
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If the effective length of a column is twice the actual length, then the column is ________
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  What is the value of Rankine's constant for cast iron?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  What is the value of shear stress acting on a plane of circular bar which is subjected to axial tensile load of 100 kN? (Diameter of bar = 40 mm , θ = 42.3°)
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The angle between normal stress and tangential stress is known as angle of ______
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Minor principal stress has minimum ________
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  According to maximum strain energy theory, failure of material due to complex stresses occurs when total stored energy per unit volume at a point ___________
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Principal stress of 30 Mpa and -70 Mpa acts on a material which has elastic limit stress in simple tension and compression as 60 Mpa and 200 Mpa respectively. Specify the reason for failure of the material assuming maximum principle stress theory.
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A circular bar is subjected to an axial force and shear force, the difference between two principle stresses is 120 Mpa. Based on maximum shear stress theory what is the factor of safety, if elastic limit of the bar is 300 Mpa?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For designing ductile materials, which of the following theories is/are used?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Shear stress energy theory is called as ______
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which gear is used if the axes of two shafts are neither intersecting nor parallel?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Spiral gears are used only if the axes of two shafts are non-intersecting, non-parallel and __________.
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In which of the following processes, tooth ends are made thinner?
Category: Mechanical Engineering Questions,   Published by: teswesm