Refrigeration & Air Conditioning Mcqs


Q.  The general rule for rating refrigeration systems (excepting for C02 system) is to approximate following h.p. per ton of refrigeration__________________?

a. 0.1 to 0.5 h.p. per ton of refrigeration
b. 0.5 to 0.8 h.p. per ton of refrigeration
c. 1 to 2 h.p. per ton of refrigeration
d. 2 to 5 h.p. per ton of refrigeration
e. 5 to 10 h.p. per ton refrigeration


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Highest temperature encountered in refrigeration cycle should be________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Absorption system normally uses the following refrigerant___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In a vapor compression cycle, the refrigerant immediately after expansion valve is___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Choose the correct statement?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Choose the wrong statement ?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Pick up the incorrect statement?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  At very low temperature, the melting and boiling temperatures become equal. This temperature is____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The latent heat of steam at pressures greater than atmospheric in comparison to latent heat at atmospheric pressure is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Carbonation of coal is the process of________________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Heating of dry steam above saturation temperature is known as_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If partial pressure of air and steam be pa and ps respectively in a condenser, then according to Dalton’s law, the pressure in condenser is equal to__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The specific volume of steam with increase in pressure decreases_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The coal requirement per kW hour generation in the thermal power plant is of the order of__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Stoichiometric quantity of air is the___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Superheating of steam is done at_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The saturation temperature of steam with increase in pressure increases____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For water, at pressures below atmospheric___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The critical pressure at which latent heat of vaporisation is zero is________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Coke is produced by__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  1 kg.m is equal to_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm