Turbo Machines Test Questions

Q.  The gates of aerofoil section in between the outer and inner ring of guide wheel are called as ________.

a. guide gates
b. guide vanes
c. scrolling gates
d. scrolling vanes


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Why is autofrettage process used in pressure vessels?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Due to which effect, compressive residual stress of strain-hardening model is smaller than elastic-perfectly plastic model?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Claviro's equation is applicable to cylinders with _______
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which equation is used to determine wall thickness for brittle materials?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the weld joint efficiency if pressure vessel is fabricated with single full fillet lap joint?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is not an unfired pressure vessel?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In unfired pressure vessels, category A consists of _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is not expressed by primary design equation?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What does Ψ mean in Lagrange's equation (LE = U + λΨ)?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are false if separate cylinder liner is pressed inside the cylinder of large engines?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of cylinder liners are used in engines having bore diameter more than 125 mm?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following materials are used for cylinder liners?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Thermal stress in cylinder liners can be reduced by _______
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which stress is induced in cylinder wall due to side thrust of the piston?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Assignable causes are caused due to changes in _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the relation between standard deviation(σ) and arithmetic mean (μ) to determine coefficient of variation (C)?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following curves have the mean value equal to zero in the graph of frequency vs random variable?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the maximum percentage loss of economic cutting speed if geometric progression ratio = 1.06 ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the geometric progression ratio if maximum and minimum spindle speeds are 500 r.p.m and 300 r.p.m respectively? (Number of speed steps = 7)
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Economic cutting speed is minimum if geometric ratio is _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts