IC Engines Mcqs

Q.  The following type of carburettor is preferred_______________?

a. concentric type
b. eccentric type
c. horizontal type
d. vertical type
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  The notch angle of the Izod impact test specimen is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Coaxing is the procedure of increasing__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Fatigue strength can be increased by__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration in cyclic loading is more serious in__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The fatigue life of a part can be improved by_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Plastic flow in ductile materials_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration is caused due to_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a load W is applied instantaneously on a bar; then the stress induced in bar will___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Tensile strength of a mild steel specimen can be roughly predicted from following hardness test_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Rankine’s theory of failure is applicable for following type of materials___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A hot short metal is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The permissible stress for carbon steel under static loading is generally taken as__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ultimate strength of steel in tension in comparison to shear is in the ratio of__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The fatigue limit of a material____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Yield point in fatigue loading as compared to static loading is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The building up of worn and uridersized parts, subjected to repeated loads by electroplating is_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which process will increase the fatigue duration of parts ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In nitrated parts, the origins of the fatigue cracks will occur at__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cold working________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts