Hydraulics & Pneumatics Test Questions

Q.  The flow rate in gear pump___________________?

a. increases with increase in pressure
b. decreases with increase in pressure
c. more or less remains constant with in-crease in pressure
d. unpredictable
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  The discharge through a reaction turbine with increase in unit speed____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Francis, Kaplan and propeller turbines fall under the category of___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Francis turbine is best suited for_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Impulse turbine is generally fitted______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In reaction turbine, draft tube is used_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A turbine pump is basically a centrifugal pump equipped additionally with_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The specific speed of turbine is defined as the speed of a unit___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Medium specific speea of turbine implies it is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Runaway speed of a hydraulic turbine is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Low specific speed of turbine implies it is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  High specific speed of a pump implies it is_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For very high discharge at low pressure such as for flood control and irrigation applications, following type of pump is preferred_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a centrifugal pump casing, the flow of water leaving the impeller, is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Supercharging is the process of_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Compression ratio of LC. engines is ___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The calorific value of gaseous fuels is expressed in terms of__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  All heat engines utilize_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Fuel oil consumption guarantees for I .C. engine are usually based on__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In case of gas turbines, the gaseous fuel consumption guarantees are based on________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The pressure and temperature at the end of compression stroke in a petrol engine are of the order of___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts