Chemical Engineering Basics Mcqs


Q.  The expected efficiency of a single riveted lap joint is of the order of 50%. If the thickness of the plate is increased four times, then the rivet diameter will have to be increased ___________________ times ?

a. Two
b. Four
c. Six
d. Eight


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Eutectoid composition of carbon steel at room temperature is___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Larger length & diameter water pipes are made by____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is an acidic constituent of B.F. slag ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Addition of _____________________ to steel does not impart hardness?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  M10 index of coke indicates its____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Dislocations are _______________ defects?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is not an ore of copper ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A common disinfectant used in village wells for disinfection of water is __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A spring material should have low__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Maximum permissible sulphur content in steel is ______________ percent ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  _______________ has a negative co-efficient of linear expansion?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is a commonly used manometric liquid for low pressure range ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The ratio of the shear stress to the principal stress on a principal plane is______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Machinability of hard alloys and tool steels is improved by_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Runge-Kutta method is used to solve a/an __________________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  _______________ is the trade name assigned to a non-ferrous cast alloy composed of cobalt, chromium & tungsten ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The minimum carbon content in steel should be ____________________ percent for it to respond to a hardening treatment ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which one of the following is incombustible ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  As the fluid flow rate increases, the float of the Rotameter____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  High speed steel tools retain their hardness upto a temperature of __________________ °C?
Category: Chemical Engineering Mcqs,   Published by: teswesm