MCQs: A steel rod 1 metre long having square cross section is pulled under a tensile load of 8 tonnes. The extension in the rod was 1 mm only. If Esteel = 2 × 106 kg/cm2, the side of the rod, is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Total strain energy theory for the failure of a material at elastic limit, is known_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The horizontal deflection of a parabolic curved beam of span 10 m and rise 3 m when loaded with a uniformly distributed load l t per horizontal length is (where Ic is the M.I. at the crown, which varies as the slope of the arch)___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Stress may be expressed in Newtons___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The vertical reaction for the arch is________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Flat spiral springs_______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: In case of a simply supported rectangular beam of span L and loaded with a central load W, the length of elastoplastic zone of the plastic hinge, is__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The stiffness of the close coil helical spring is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The ratio of the length and diameter of a simply supported uniform circular beam which experiences maximum bending stress equal to tensile stress due to same load at its mid span, is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The ratio of shear stress and shear strain of an elastic material, is________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: At yield point of a test piece, the material__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The ratio of moments of inertia of a triangular section about its base and about a centroidal axis parallel to its base, is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The ratio of the deflections of the free end of a cantilever due to an isolated load at 1/3rd and 2/3rd of the span, is________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: In plastic analysis, the shape factor for a circular section, is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The maximum magnitude of shear stress due to shear force F on a rectangular section of area A at the neutral axis, is__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: For beams of uniform strength, if depth is constant______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: There are two hinged semicircular arches A, B and C of radii 5 m, 7.5 m and 10 m respectively and each carries a concentrated load W at their crowns. The horizontal thrust at their supports will be in the ratio of_______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The equivalent length of a column of length L, having both the ends hinged, is_______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Stress may be defined as_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: For permissible shear stress fs, the torque transmitted by a thin tube of mean diameter D and wall thickness t, is________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts
