Production Technology Mcqs


Q.  The difference between the time available to do the job and the time required to do the job, is known as_________________?

a. event
b. float
c. duration
d. constraint
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  According to Rowan plan, if H = hourly rate, A = actual time and S = standard time, then wages will be___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  One of the basic essentials of an incentive plan is that_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following is not wage incentive plan_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Pick up the correct statement from the following?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Pick up the correct statement from the following?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Pick up the incorrect statement from the following?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Pick up the correct statement from the following?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A file removes the metal during___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In a _____________ , both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A neutral flame is obtained by supplying___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The cold working of metals is carried out_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Lancing is the operation of _________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In spot welding, the spacing between two spot weld should not be less than _______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The shrinkage allowance for cast iron pattern is________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Tandem drawing of wires and tubes is necessary because_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The operation of straightening a curved sheet metal, is known as____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following statement is wrong ?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following cycles uses air as the refrigerant__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The relative coefficient of performance is_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Clapeyron equation is applicable for registration at___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm