Design of Machine Elements

Q.  The crest diameter of a screw thread is same as _____________________?

a. major diameter
b. minor diameter
c. pitch diameter
d. core diameter
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia of rivet d should be equal to__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Transverse fillet welded joints are designed for________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The pitch of threads on a Jock nut in comparison to pitch of nut is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In order to obtain bolt of uniform strength____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A key made from a cylindrical disc having segmental cross-section, is known as______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Fibrous fracture occurs in_____________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Eye bolts are used for_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Taper usually provided on cotter is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The draw of cotter need not exceed_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The valve rod in a steam engine is connected to an eccentric rod by_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Taper on the cotter and slot is provided_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Silver-based solder is used for__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In order to permit the thermal expansion/contraction of tubing, it should be______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The strap end of a connecting rod of steam engine is joined by_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shear plane in case of bolts should_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a nut is tightened by plaping a washer below it, the bolt will be subjected to following type of loads___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The edges of the plates for cylindrical vessels are usually bevelled to an angle of 80° for_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following pipe joints would be suitable for pipes carrying steam_____________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shearing stresses in the inner face as compared to outer face of the wire in a heavy close coiled spring is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts