Steam Boilers, Engines, Nozzles & Turbines Mcqs

Q.  The basic job of feed water treatment in boilers is to overcome the problem of __________________?

a. corrosion
b. scale
c. carryover
d. embrittlement
e. all of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Pour point of fuel oil is the____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Gusset stays in a boiler are provided to____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Sulphur content of fuels is very important to the plant operators because it____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  An economiser in a boiler______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Spontaneous combustion is a phenomenon in which____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Ultimate analysis of fuel is determination of percentage of____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which device is used in thermal power plants to reduce level of pollution___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The maximum discharge through a chimney occurs when the height of chimney is_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In locomotives, the draught is produced by_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Vacuum for reciprocating steam engines compared to steam turbines is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The height of chimney in a power plant is governed by__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The function of injector used in small capacity boilers is to____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In designing air preheater, the important design consideration is that_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The temperature of flue gases at air heater outlet should be__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a recuperative air preheater, the heat is transferred____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  With increase in load, convection superheater has_______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In which of the following boilers, the draught in furnace is increased by utilising exhaust steam from engine__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The heat loss in a boiler takes place in the form of________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In forced circulation type boiler__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The overall efficiency of thermal power plant is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts