Surveying Mcqs


Q.  The angle between the prolongation of the preceding line and the forward line of a traverse is called ________________?

a. deflection angle
b. included angle
c. direct angle
d. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The ruling design speed on a National Highway in plain terrain as per IRC recommendations is_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The effect of grade on safe overtaking sight distance is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Stopping sight distance is always_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The terrain may be classified as rolling terrain if the cross slope of land is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For the design of super elevation for mixed traffic conditions, the speed is reduced by_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For a constant value of coefficient of lateral friction, the value of required super-elevation increases with_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  As per IRC recommendations, the maximum limit of super elevation for mixed traffic in plain terrain is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  On a horizontal curve if the pavement is kept horizontal across the alignment, then the pressure on the outer wheels will be_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The attainment of super elevation by rotation of pavement about the inner edge of the pavement_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  To calculate the minimum value of ruling radius of horizontal curves in plains, the design speed is given by_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In case of hill roads, the extra widening is generally provided______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum design gradient for vertical profile of a road is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The transition curve used in the horizontal alignment of highways as per IRC recommendations is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The absolute minimum radius of curve for safe operation for a speed of 110 kmph is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Select the correct statement_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For design, that length of transition curve should be taken which is_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If ruling gradient is I in 20 and there is also a horizontal curve of radius 76 m, then the compensated grade should be_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following shapes is preferred in a valley curve ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The percentage compensation in gradient for ruling gradient of 4% and horizontal curve of radius 760 m is____________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The camber of road should be approximately equal to___________________?
Category: Civil Engineering Mcqs,   Published by: teswesm