Stoichiometry Mcqs for Chemical


Q.  The amount of Zn (atomic weight = 65) required to form 224 c.c. of H2 at N.T.P. on treatment with dilute H2SO4will be _____________ gm?

a. 0.065
b. 0.65
c. 6.5
d. 65


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Pure aniline is evaporating through a stagnant air film of 1 mm thickness at 300 K and a total pressure of 100 KPa. The vapor pressure of aniline at 300 K is 0.1 KPa. The total molar concentration under these conditions is 40.1 mole/m3. The diffusivity of aniline in air is 0.74 × 10-5m2/s. The numerical value of mass transfer co-efficient is 7.4 × 10-3. Its units are_______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Pick out the wrong unit conversion of thermal conductivity ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  For any system, the _____________ heat of solution is dependent on the temperature and the adsorbate concentration?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following expressions defines the Baume gravity scale for liquids lighter than water ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Variation of vapor pressure with temperature can be calculated using Clausius-Clapeyron equation, which assumes that the________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  1 gm mole of an alcohol whose molecular weight is 74 contains 48 gms of carbon, 10 gms of hydrogen and 16 gms of oxygen. Its molecular formula is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Raoult’s law states that ‘the equilibrium vapor pressure that is exerted by a component in a solution is proportional to the mole fraction of that component’. This generalisation is based on the assumption that the________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The increase in the temperature of the aqueous solution will result in decrease of its________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The vapor pressure of a substance, at its melting point, is _____________ in the solid state as compared to that in the liquid state?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In case of vapor-liquid equilibria, which of the following does not account for gas phase deviation from ideality ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following ideal gas laws are not applicable to mixture of gases ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Solutions having the same osmotic pressure are called _____________ solutions?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The molecular velocity of a real gas is proportional to (where, T = absolute temperature of the gas)?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following gases is the most soluble in water ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A reduction process is accompanied with increase in the_______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The unit of dynamic viscosity is_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Unit of power is____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  1 kg/m2 is equal to ______________ mm water column?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Except for monatomic gases, the molal heat capacity at constant volume for all gases is _____________ Kcal/Kg mole.° K?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The crystallisation of a solute from a solution may be done by________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm