Metallurgy Test Questions

Q.  The alloy of Ti + 5% Al, + 2.5 Sn has _______.

a. low temperature stability
b. low strength
c. good corrosion
d. all of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which type of screw fasteners are threaded at both the ends?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What does the designation M 16 x 2 indicate?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of screw fasteners are threaded through out its length?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of joint is used if plate thickness is less than 5 mm?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate weld size if weld throat thickness for the fillet weld is 8.2 mm
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Free length for helical compression springs having square ends is given as ________.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the Wahl's factor if spring index is 6?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Why are mechanical springs used?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true? 1. In volute springs, number of active coils gradually decreases as load increases 2. Stiffness of spring decreases as number of coils decreases in conical springs 3. Torsion springs are generally spiral 4. Helical torsion springs are used in automobile starters
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In which condition the axial distance between two adjacent coils is called as pitch?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The application factor depends on ______
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by application factor?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by Aesthetics?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Series of numbers offered by arithmetic progression are called as preferred series
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is a knuckle joint?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What are assumptions made during stress analysis of curved beams?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which factors are responsible for the failure of a component due to buckling?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A shaft transmits power of 30 kW. According to maximum principle stress theory and shear theory diameter of shaft is 70 mm and 73 mm respectively. Tensile stress acting on the shaft is 50 Mpa. What will be the shaft diameter to transmit power?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Universal coupling is a type of ____
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts