Metrology & Quality Control Test Questions

Q.  Testing flatness or straightness of a surface is possible using

a. vernier caliper
b. micrometer
c. autocollimator
d. all of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  On operating characteristics curve, consumers risk is denoted by
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  ISO 14000 quality standard is related with
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which ISO standard is used in international automobile companies to set automotive quality system standards ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a characteristic of End standard?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is measured using four ball method?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Internal diameter of any workpiece can be measured using
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is/are the factor(s) causing runout?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The snap gauge having go dimension corresponds to
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of deviation is observed while calculating hole dimensions?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At which angle does a glass plate reflector set in N.P.L. interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of surface in a fringe pattern exhibits the movement of fringes towards the centre?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is ten point height method?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What effect does pitch error have on nut and bolt?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  According to Taylor's principle which type of gauge checks both size and geometric features?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which formula is used to calculate diametral pitch?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Analytical checking of gears includes checking of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the function of frame grabber?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In image shearing techniques, what is meant by single shear?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts