|
MCQs: One of the specific gravity scales is “Brix” (used specifically for sugar solution). It is defined as ______________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: With rise in temperature, the heat capacity of a substance___________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: For a neutral solution (pH = 7), the value of [H+] [OH-] is equal to_________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: A compound was found having nitrogen and oxygen in the ratio 28 gm and 80 gm respectively. The formula of the compound is_________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: The heat capacity of a solid compound is calculated from the atomic heat capacities of its constituent elements with the help of the___________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: A solution with reasonably permanent pH is called a/an _______________ solution?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: Molality is defined as the number of gm moles of solute per _____________ of solvent?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: Weight of 56 litres of ammonia at N.T.P. is _____________ gm?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: Which of the following is the Clausius-Clapeyron Equation ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: The value of Trouton’s ratio (λb/Tb) for a number of substances is 21 (where, λb = molal that of vaporisation of a substance at its normal boiling point, KCal/kg. mole and Tb = normal boiling point, °K). The Kistyakowsky equation is used for calculation of Trouton’s ratio of _____________ liquids?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: The reverse process of fractional crystallisation is called__________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: Pure aniline is evaporating through a stagnant air film of 1 mm thickness at 300 K and a total pressure of 100 KPa. The vapor pressure of aniline at 300 K is 0.1 KPa. The total molar concentration under these conditions is 40.1 mole/m3. The diffusivity of aniline in air is 0.74 × 10-5m2/s. The numerical value of mass transfer co-efficient is 7.4 × 10-3. Its units are_______________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: Pick out the wrong unit conversion of thermal conductivity ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: For any system, the _____________ heat of solution is dependent on the temperature and the adsorbate concentration?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: Which of the following expressions defines the Baume gravity scale for liquids lighter than water ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: Variation of vapor pressure with temperature can be calculated using Clausius-Clapeyron equation, which assumes that the________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: 1 gm mole of an alcohol whose molecular weight is 74 contains 48 gms of carbon, 10 gms of hydrogen and 16 gms of oxygen. Its molecular formula is__________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: Raoult’s law states that ‘the equilibrium vapor pressure that is exerted by a component in a solution is proportional to the mole fraction of that component’. This generalisation is based on the assumption that the________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: The increase in the temperature of the aqueous solution will result in decrease of its________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
|
MCQs: The vapor pressure of a substance, at its melting point, is _____________ in the solid state as compared to that in the liquid state?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
