Design of Machine Elements

Q.  Stress concentration is caused due to_____________________?

a. variation in properties of material from point to point in a member
b. pitting at’points or areas at which loads on a member are applied
c. abrupt change of section
d. all of the above
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  A stud________________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A tap bolt_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The included angle in unified of American National threads is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cap screws are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Set screws are_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  An alien bolt is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Ball bearing type screws are found in following application_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The function of a washer is to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For applications involving high stresses in one direction only the following type of thread would be best suited______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Shear stress theory is applicable for____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The following type of nut is used with alien bolt____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A bolt___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The endurance limit in shear of carbon steel can be obtained by multiplying the endurance limit in flexure by a factor of____________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which is correct statement ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A self locking screw has________________>
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Machine screws are________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The edges of a boiler plate are bevelled to an angle of______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia of rivet d should be equal to__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts