Design of Machine Elements

Q.  Stress concentration in cyclic loading is____________________?
Which is correct statement ?


a. very serious in brittle materials and less serious in ductile materials
b. very serious in ductile materials and less serious in brittle materials
c. equally serious in both types of materials
d. seriousness would depend on other factors
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which process will increase the fatigue duration of parts ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In nitrated parts, the origins of the fatigue cracks will occur at__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cold working________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Residual stress in materials_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ratio of endurance limit in shear to the endurance limit in flexure is__________________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Resistance to fatigue of a material is measured by________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For steel, the ultimate strength in shear as compared to ultimate strength in tension is ___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At low temperatures (say 75°C) the notched-bar impact value of steel____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The crest diameter of a screw thread is same as _____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Maximum principal stress theory is applicable for_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A stud________________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A tap bolt_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The included angle in unified of American National threads is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cap screws are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Set screws are_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  An alien bolt is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Ball bearing type screws are found in following application_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The function of a washer is to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For applications involving high stresses in one direction only the following type of thread would be best suited______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts