Power Electronics Mcqs


Q.  Spread time is defined as the interval during which_____________?

a. anode voltage drops from 10 % of its initial value to zero
b. anode current rises from 90 % to its final value
c. both (A) and (B)
d. anode current rises from 10 % to 90 % of its final value


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Thyristor is nothing but a____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Gate circuit or triggering circuit of a thyristor is
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  After proper turn on of thyristor____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  SCR will be turned off when anode current is_______________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The capacitance of reversed bised junction J2 in a thyristor is CJ2 = 20 pF and can be assumed to be independant of the off state voltage. The limiting value of the charging current to turn on the thyristor is 16 mA. What is the critical value of dv/dt?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  BCT is used for____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Let of a thyristor Vc1, Vc2, Vc3 are forward break over voltage for gate current Ig1, Ig2, Ig3 respectively. Then________________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Which of following devices has highest di/dt and dv/dt capability?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Which triggering is the most reliable____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Leakage current flows through the thyristor in_________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following is disadvantage of fast recovery diodes?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  When a large surge current of very short duration flows through a thyristor then which one of the following device will operate to protect the thyristor ___________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  A power semiconductor may undergo damage due to____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  CB used for over current protection of thyristor operates when the fault current is__________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  If the anode current is 800 A, then the amount of current required to turn off the GTO is about____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  What is used to protect the SCR from over current ________________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Under normal operating condition voltage clamping device offers impedance of_________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Which semiconductor device acts like a diode and two transistor?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Under over voltage condition impedance offered by the voltage clamping device is__________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The latching current of GTO should be of order
Category: Electrical Engineering Questions,   Published by: teswesm