Water Management Mcqs


Q.  Sliding failure occurs in a solid gravity dam when____________________?

a. Resultant of all forces cuts the base of the dam out side the toe
b. Resultant of all forces cuts the base at the inner middle third point
c. Ratio of over turning moments exceeds than unity
d. Shear friction factor Is less than 1.5


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The angle between a head regulator and entrance of water, for smooth entry of water in a canal is kept as _________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  A closed conduct or barrel used used for supplying water under high pressure to a turbine to generate electricity is called __________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  An earth embankment built on one or both sides of a river, some distance away from its banks to control flood is called _______________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  A pipe flowing full, the liquid particles in the pipe has maximum velocity at __________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  The hydraulic gradient line (H.G.L)represents the sum of_________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  velocity of gases is measured with a _____________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  From a water fall, if water is falling down at the rate of 100 N/sec: on the blades of a turbine when the height of fall is 100 m the power delivered to turbine will be______________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  Mercury does not wet the glass because of its property of ______________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  A type of flow in which water particles, while moving in the direction of flow, rotate about their mass centre is called _________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  Permissible velocity of water flowing through concrete lined tunnel is usually __________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  The depth of flow at which the energy is maximum is called ____________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  Water application efficiency increases if the plot to be irrigated is__________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  Water available above the top of root zone of plants is about 15% of soil moisture contents, is mostly not available to plants celled_________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  Wilting point is that limit after that the crop starts feeding up and no water is available for plant, this point occurs after _________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  Estimated quantity of global water is __________which covers about 70% of earth?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  _________% of total global water is fresh and its major portion is obtained from Rains ?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  The property of soil which indicates the volume of water stored in the formation is called ___________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  The property of saturated soil mass which transmits appreciable quantities . water is called___________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  The discharge of a well per unit draw down usually expressed as gallons or liters per minute is called ____________________?
Category: Agriculture Mcqs,   Published by: teswesm
MCQs:  Ground water moving down wards in the un-saturated ground above the water table is called___________________?
Category: Agriculture Mcqs,   Published by: teswesm