Design of Concrete Structures Mcqs


Q.  Sinking of an intermediate support of a continuous beam_____________?
1. reduces the negative moment at support
2. increases the negative moment at support
3. reduces the positive moment at center of span
4. increases the positive moment at center of span
The correct answer is?


a. (1) and (3)
b. (1) and(4)
c. (2 )and (3)
d. (2) and (4)


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  When the degree of saturation is zero, the soil mass under consideration represents______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Select the correct range of density index,ID ________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the volume of voids is equal to the volume of solids in a soil mass, then the values of porosity and voids ratio respectively are________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the water content of a fully saturated soil mass is 100%, then the voids ratio of the sample is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Relative density of a compacted dense sand is approximately equal to_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following methods is most accurate for the determination of the water content of soil ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The ratio of volume of voids to the total volume of soil mass is called______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the degree of saturation of a partially saturated soil is 60%, then air content of the soil is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the sand in-situ is in its densest state, then the relative density of sand is_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A pycnometer is used to determine_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In hydrometer analysis for a soil mass______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For proper field control, which of the following methods is best suited for quick determination of water content of a soil mass ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A soil has a bulk density of 22 kN/m3 and water content 10 %. The dry density of soil is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Stoke’s law is valid only if the size of particle is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is a measure of particle size range ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Uniformity coefficient of a soil is__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The hydrometer method of sedimentation analysis differs from the pipette analysis mainly in_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  According to Atterberg, the soil is said to be of medium plasticity if the plasticity index PI is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the plasticity index of a soil mass is zero, the soil is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  When the plastic limit of a soil is greater than the liquid limit, then the plasticity index is reported as_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm