Design of Machine Elements

Q.  Silver-based solder is used for__________________?

a. flaring
b. brazing
c. soft soldering
d. fusion welding
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  I.S. specifies following total number of grades of tolerances__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Allen bolts are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The connecting rod bolts are tightened up so that tightening stress _________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shock absorbing capacity of a bolt can be increased by___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The connecting rod bolts are tightened up with initial tension greater than the external load so that___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The resultant axial load on a bolt depends on_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Basic hole is one_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In cross or regular lay ropes_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In V-belt drive, belt touches______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The rated life of a bearing varies___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In hydrostatic bearings ____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If p = bearing pressure on projected bearing area, z = absolute viscosity of lubricant, and N = speed of journal, then the bearing characteristic number is given by________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In hydrodynamic bearings_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Aircraft body is usually fabricated by_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a spring is cut down into two springs, the stiffness of cut springs will be _________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When two springs are in series (having stiffness K), the equivalent stiffness will be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts