Highway Engineering Mcqs

Q.  Select the correct statement________________?

a. Quantity of binder required for tack coat is less than that required for prime coat
b. Prime coat treatment is given for plugging the voids in water bound macadam during bituminous road construction
c. Seal coat is the final coat over certain previous bituminous pavements
d. A bitumen primer is a high viscosity cutback


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Air entrainment in the concrete increases________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Workability of concrete is inversely pro¬portional to______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The property of fresh concrete, in which the water in the mix tends to rise to the surface while placing and compacting, is called________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  To determine the modulus of rupture, the size of test specimen used is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The percentage of voids in cement is approximately_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Modulus of rupture of concrete is a measure of_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In order to obtain the best workability of concrete, the preferred shape of aggregate is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As compared to ordinary portland cement, high alumina cement has______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Bulking of sand is maximum if moisture content is about____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  1% of voids in a concrete mix would reduce its strength by about______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Finer grinding of cement______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Poisson’s ratio for concrete_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The factor of safety for______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The fineness modulus of fine aggregate is in the range of______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The compressive strength of 100 mm cube as compared to 150 mm cube is always_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If a beam fails in bond, then its bond strength can be increased most economi-cally by___________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the depth of actual neutral axis in a beam is more than the depth of critical neutral axis, then the beam is called________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the permissible stress in steel in tension is 140 N/mm2, then the depth of neutral axis for a singly reinforced rectangular balanced section will be___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum grade of concrete to be used in reinforced concrete as per IS:456-1978 is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Maximum quantity of water needed per 50 kg of cement for M 15 grade of concrete is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts