Hydraulics & Pneumatics Test Questions

Q.  Saving of work done and power by fitting an air vessel to double acting reciprocating pump is of the order of_______________?

a. 39.2%
b. 49.2%
c. 68.8%
d. 84.8%
e. 91.6%.


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  High specific speed of a pump implies it is_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For very high discharge at low pressure such as for flood control and irrigation applications, following type of pump is preferred_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a centrifugal pump casing, the flow of water leaving the impeller, is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Supercharging is the process of_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Compression ratio of LC. engines is ___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The calorific value of gaseous fuels is expressed in terms of__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  All heat engines utilize_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Fuel oil consumption guarantees for I .C. engine are usually based on__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In case of gas turbines, the gaseous fuel consumption guarantees are based on________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The pressure and temperature at the end of compression stroke in a petrol engine are of the order of___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The maximum temperature in the I.C. engine cylinder is of the order of ________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The fuel in diesel engine is normally injected at pressure of_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Crankcase explosion in I.C. engines usuall occurs as ___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The specific fuel consumption per BH hour for a petrol engine is approximately__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The inlet value of a four stroke cycle I.C engine remains open for nearly___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If one cylinder of a diesel engine receives more fuel than the others, then for that cylinder the________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  It the temperature of intake air in IC engines is lowered, then its efficiency will_______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For the same compression ratio_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  As a result of detonation in an I.C. engine, following parameter attains very high value _____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Most high speed compression engines operate on __________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts