Highway Engineering Mcqs

Q.  Rigidity factor for a tyre pressure greater than 7 kg/cm2 is_______________?

a. equal to 1
b. less than 1
c. greater than 1
d. zero


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Select the correct statement________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is considered to be the highest quality construction in the group of black top pavements ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following represents a carpet of sand-bitumen mix without coarse aggregates ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The drain which is provided parallel to roadway to intercept and divert the water from hill slopes is known as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In hill roads the side drains arc provided________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The minimum design speed for hairpin bends in hill roads is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In highway construction on super elevated curves, the rolling shall proceed from_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The camber for hill roads in case of bituminous surfacing is adopted as________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The property of the ingredients to separate from each other while placing the concrete is called____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Approximate value of shrinkage strain in concrete, is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Workability of concrete is directly proportional to________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The relation between modulus of rupture fcr, splitting strength fcs and direct tensile strength fcl is given by_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Strength of concrete increases with________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As compared to ordinary portland cement, use of pozzuolanic cement_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  According to IS : 456 -1978, the modulus of elasticity of concrete Ec (in N/mm2) can be taken as______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The most commonly used admixture which prolongs the setting and hardening time is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The strength of concrete after one year as compared to 28 days strength is about_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Admixtures which cause early setting, and hardening of concrete are called_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Increase in the moisture content in concrete_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The relation between modulus of rupturefcr and characteristic strength of concrete fck is given by_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts