Design of Machine Elements


Q.  Resilience of a material is important, when it is subjected to________________?

a. combined loading
b. fatigue
c. thermal stresses
d. wear and tear
e. shock loading


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Tensile strength of a mild steel specimen can be roughly predicted from following hardness test_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Rankine’s theory of failure is applicable for following type of materials___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A hot short metal is_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The permissible stress for carbon steel under static loading is generally taken as__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The ultimate strength of steel in tension in comparison to shear is in the ratio of__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The fatigue limit of a material____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Yield point in fatigue loading as compared to static loading is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The building up of worn and uridersized parts, subjected to repeated loads by electroplating is_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which process will increase the fatigue duration of parts ?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In nitrated parts, the origins of the fatigue cracks will occur at__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Cold working________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Residual stress in materials_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The ratio of endurance limit in shear to the endurance limit in flexure is__________________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Resistance to fatigue of a material is measured by________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For steel, the ultimate strength in shear as compared to ultimate strength in tension is ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  At low temperatures (say 75°C) the notched-bar impact value of steel____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The crest diameter of a screw thread is same as _____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Maximum principal stress theory is applicable for_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A stud________________________?
Category: Mechanical Engineering Questions,   Published by: teswesm