Metrology & Quality Control Test Questions

Q.  Relaxed ambiance for group participation is observed in which type of brain storming sessions?

a. structured sessions
b. unstructured sessions
c. both a. and b.
d. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  A gear has 30 teeth with module 4 mm and pressure angle of 20°. Calculate length of base tangent in a gear over 7 teeth space.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a contact type of automated inspection method?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which are the different techniques used by interpretation segments for interpretation?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which formula is used to calculate quality of performance?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following strategies of Deming's fourteen points is included into category of Management commitment?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following depicts positive and negative relation between driving factor and performance factor?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of chart uses the rule of 20:80?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is true? 1. P and nP charts cannot use limit gauges 2. P charts are difficult to understand 3. P charts cannot recognize different degrees of defectiveness in units
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true? 1. Probability of acceptance decreases if acceptance number increases, when sampling size is kept constant 2. Indifferent quality range is the range between lot tolerance percent defective and acceptable quality level 3. Operating characteristics curve is the curve plotted between probability of acceptance and indifferent quality range
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  On operating characteristics curve, consumers risk is denoted by
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  ISO 14000 quality standard is related with
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which ISO standard is used in international automobile companies to set automotive quality system standards ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a characteristic of End standard?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is measured using four ball method?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Internal diameter of any workpiece can be measured using
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is/are the factor(s) causing runout?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The snap gauge having go dimension corresponds to
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of deviation is observed while calculating hole dimensions?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At which angle does a glass plate reflector set in N.P.L. interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts