Highway Engineering Mcqs

Q.  Reaction time of a driver_______________?

a. increases with increase in speed
b. decreases with increase in speed
c. is same for all speeds
d. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  The percentage compensation in gradient for ruling gradient of 4% and horizontal curve of radius 760 m is____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The camber of road should be approximately equal to___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In case of summit curves, the deviation angle will be maximum when_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Enoscope is used to find______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If an ascending gradient of 1 in 50 meets a descending gradient of 1 in 50, the length of summit curve for a stopping sight distance of 80 m will be_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The value of ruling gradient in plains as per IRC recommendation is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the design speed is V kmph and deviation angle is N radians, then the total length of a valley curve in meters is given by the expression_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Highway facilities are designed for_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For highway geometric design purposes the speed used is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum width of a vehicle as recommended by IRC is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Select the correct statement__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following methods is preferred for collecting origin and destination data for a small area like a mass business center or a large intersection ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Length of a vehicle affects________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Desire lines are plotted in_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The diagram which shows the approximate path of vehicles and pedestrians involved in accidents is known as___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is known as design capacity ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Equivalent factor of passenger car unit (PCU) for a passenger car as per IRC is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  With increase in speed of the traffic stream, the minimum spacing of vehicles________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  With increase in speed of the traffic stream, the maximum capacity of the lane________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the stopping distance and average length of a vehicle are 18 m and 6 m respectively, then the theoretical maxi¬mum capacity of a traffic lane at a speed of 10 m/sec is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts