Irrigation, Water Resources Engineering & Hydrology Mcqs

Q.  Rate of evaporation from a water surface increases if_________________?
1) difference of vapour pressure between water and air is increased
2) velocity of wind is decreased
3) concentration of soluble solids in water is decreased
The correct answer is?


a. (1) and (i2)
b. (2) and (3)
c. (2) and (3)
d. (1), (2) and (3)


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Assertion A : Large size stones are required in stone revetment in shore protection. Reason R : Resistance of stone to wave force is proportional to its volume and wave force is proportional to the exposed area of the stone? Select your answer based on the coding system given below
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following structures protects the shore by trapping of littoral drift?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For designing the dock, the proportion of ship load assumed to be borne by keel blocks is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A ship is berthed in a chamber and lifted by principles of buoyancy Such a chamber is called_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A ship strikes the berth generally at an angle_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following conditions of loading imposes the greatest load on the foundation in case of dry docks?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following are repair docks ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following type of sea walls results in greatest protection of shore structures?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  When a wave strikes a vertical breakwater in deep water, it is reflected back and on meeting another advancing wave of similar amplitude merges and rises vertically in a wall of water. This phenomenon is called_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The significant wave height is defined is the average height of the_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  By increasing the rise of lockgates_______________? (i) the length of the lock gate will increase (ii) transverse stress due to water pressure on the gate will increase (iii) compressive force on the gate will increase select the correct statements?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If H is the height of the wave expected, then the height of the breakwater is generally taken as______________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The difference in height between highest high water and lowest low water is called_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Select the incorrect statement ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a two lane channel, bottom width of channel is given by_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As per Berlin’s formula, the length of wave in metres is given by_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In basins subjected to strong winds and tide, the length of the berthing area should not be less than____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Assertion A : Depth and width required at the entrance to a harbour are more than those required in the channel. Reason R : The entrance to a harbour is usually more exposed to waves as compared to the harbour itself__________________? Select your answer based on the coding system given below.
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum harbour depth below lowest low water is generally equal to_________________? (i) loaded draft + 1.2 m when bottom is rock (ii) loaded draft + 1.8 m when bottom is soft (iii) loaded draft + 1.2 m when bottom is soft (iv) loaded draft + 1.8 m when bottom is rock select the correct the correct statements.
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Dead weight tonnage of a ship_______________? i) varies with latitude and season ii) is more than displacement tonnage iii) is the difference between displacement load and displacement light select the correct statemens.
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts