IC Engines Mcqs


Q.  Power impulses from an I.C. engine are somoothed out by__________________?

a. governor
b. crank shaft
c. gear box
d. flywheel
e. timing spark properly


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  In the case of petrol engine at maximum output, the percentage of CO in exhaust gases is ____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In a diesel engine, injection pressure developed by injector is of the order of______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In precombustion chamber in diesel engine________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The thermal efficiency of a semi-diesel cycle having fixed compression ratio and fixed quantity of heat, with increase in pressure ratio will_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In the case of compression ignition engine, the %age of CO in exhaust gases is________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A two stroke engine is usually identified by__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A two stroke crank compressed engine has following ports in the cylinder_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Scavenging air is supplied to a two-stroke engine at a density greater than that of atmosphere. This means the engine is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In turbulence chamber in diesel engine__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If petrol is used in a diesel engine, then______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Deposition of carbon in petrol engine cylinder would result in increase of__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The part load efficiency of a carburettor is,___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The basic requirement of a good combustion chamber is___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The following type of carburettor is preferred_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The theoretically correct mixture of air and petrol is approximately ________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Carburretion is done to________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  With increase in engine speed, the ignition of spark in petrol engine has to be __________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Pick up false statement?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The property of a material which enables it to resist fracture due to high impact loads is known as__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Guest’s theory of failure is applicable for following type of materials_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm