Polymer Technology Mcqs for Chemical


Q.  Plastic articles are normally produced by _____________ moulding?

a. Green sand
b. Injection
c. Shell
d. Dry sand


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  What is the overall transfer function (C/R) of the following block diagram if G = G1. G2. G3 and H = H1.H2 ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Working principle of mercury in glass thermometer is based on the ______________ of mercury with increase in temperature?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Change of angle of refraction with composition comprises the working principle of a___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Mcleod gauge is used to measure the __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A non-linear system will have _____________ steady state values?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  On-off control which is a special case of proportional control, has a band width of about _____________ percent?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In a feed-back control system G and H denote open loop and close loop transfer functions respectively. The output-input relationship is_____________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Nitrogen gas constant volume thermometer is suitable for measuring a temperature of _____________ °C?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Mercury thermometer can be used to measure the temperature upto ____________ °C?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The Laplace transform of exp(at), where a > 0, is defined only for the Laplace parameter, s > a since______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Temperature of _____________ cannot be measured by an optical or radiation pyrometer?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Platinum resistance thermometer can be used upto antimony point which is ____________ °C, and is the temperature of equilibrium between solid antimony & liquid antimony at normal atmospheric pressure?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following thermocouples has the least temperature measurement range ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Radiation thermometer cannot measure the temperature ___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The transfer function for an ideal proportional plus reset controller (reset time T) is_______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A pyranometer is an instrument used for measuring the___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Thermistors are made of__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Stabilising time for the controllers is the time required for the response to reach _____________ percent of its ultimate value?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The initial value (t = 0) of the unit step response of the transfer function [(s + 1)/(2s + 1)] is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Normal mercury thermometer can be used to measure a temperature of about 300°C. However, its maximum temperature measurement range can be increased upto about 500°C by__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm