Building Materials & Construction Mcqs

Q.  Pitched and sloping roofs are suitable for________________?

a. coastal regions
b. plain regions
c. covering large areas
d. all of the above


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  The correction for sag is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following methods of offsets involves less measurement on the ground?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The allowable length of an offset depends upon the______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For a well-conditioned triangle, no angle should be less than______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  During chaining along a straight line, the . leader of the party has 4 arrows in his hand while the follower has 6. Distance of the follower from the starting point is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The angle of intersection of the two plane mirrors of an optical square is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following angles can be set out with the help of French cross staff?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The permissible error in chaining for measurement with chain on rough or hilly ground is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Normal tension is that pull which_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the length of a chain is found to be short on testing, it can be adjusted by______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Cross staff is an instrument used for________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is not used in measuring perpendicular offsets ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For a line AB_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the true bearing of a line AB is 269° 30′, then the azimuth of the line AB is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The length of a chain is measured from_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum tolerance in a 20 m chain is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Select the incorrect statement?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For accurate work, the steel band should always be used in preference to chain because the steel band______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the prismatic compass______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the quadrantal bearing system, a whole circle bearing of 293° 30′ can be expressed as______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts