Design of Steel Structures Mcqs

Q.  Pitch of tacking rivets, when double angles connected back to back and acting as tension members should not be more than_________________?

a. 500 mm
b. 600 mm
c. 1000 mm
d. 300 mm


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Minimum pitch provided in riveted steel tanks is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As per IS : 875, for the purposes of specifying basic wind velocity, the country has been divided into_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The external wind pressure acting on a roof depends on__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The basic wind speed is specified at a height ‘h’ above mean ground level in an open terrain. The value of’h’ is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The live load for a sloping roof with slope 15°, where access is not provided to roof, is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The minimum thickness of plates in a steel stack should be___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum permissible span of asbestos cement sheets is______________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum spacing of vertical stiffeners is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Bearing stiffeners are provided at________________? i) the supports ii) the mid span iii) the point of application of concentrated loads The correct answer is?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The forces acting on the web splice of a plate girder are__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum spacing of vertical stiffeners is limited to________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Intermediate vertical stiffeners in a plate girder need be provided if the depth of web exceeds___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The web crippling due to excessive bearing stress can be avoided by_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Horizontal stiffener in a plate girder is provided to safeguard against_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Economical depth of a plate girder corresponds to_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The overlap of batten plates with the main members in welded connections should be more than____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Battening is preferable when the________________? i) column carries axial load only ii) space between the two main components is not very large iii) column is eccentrically loaded The correct answer is
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Lacing bars in a steel column should be designed to resist_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts