IC Engines Mcqs

Q.  Pick up false statement?

a. For petrol and large gas engines, quantity governingds preferred
b. In quantity governing, air fuel ratio is almost constant and quantity of charge is changed depending on load
c. In hit and miss governing, fuel supply is completely cut off during one or more number of cycles
d. In quality governing, quantity of fuel is varied to suit the load and total charge of air is varied
e. For close regulation of speed, combination of both quality and quantity governing is used


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The fatigue life of a part can be improved by_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Plastic flow in ductile materials_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration is caused due to_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a load W is applied instantaneously on a bar; then the stress induced in bar will___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Tensile strength of a mild steel specimen can be roughly predicted from following hardness test_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Rankine’s theory of failure is applicable for following type of materials___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A hot short metal is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The permissible stress for carbon steel under static loading is generally taken as__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ultimate strength of steel in tension in comparison to shear is in the ratio of__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The fatigue limit of a material____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Yield point in fatigue loading as compared to static loading is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The building up of worn and uridersized parts, subjected to repeated loads by electroplating is_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which process will increase the fatigue duration of parts ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In nitrated parts, the origins of the fatigue cracks will occur at__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cold working________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Residual stress in materials_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ratio of endurance limit in shear to the endurance limit in flexure is__________________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Resistance to fatigue of a material is measured by________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For steel, the ultimate strength in shear as compared to ultimate strength in tension is ___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts