Nuclear Power Engineering Mcqs for Chemical


Q.  Pick out the wrong statement?

a. The nucleus of a hydrogen atom is identical with a proton
b. A, β-ray particle is identical with an electron
c. Mass of an electron is about 1/1800th of the lightest nucleus
d. Positron is heavier than a proton


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Salt content (measured as sodium chloride) in electrically desalted crude oil comes down to a level of about __________________ ptb (pounds per thousand barrel) ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  LPG stands for ____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Char value of Kerosene is the amount of charred oil deposition on the wick obtained after burning it in a standard wick lamp at a standard rate for 24 hours. Char value of a good quality kerosene should be less than ________________ mg/kg of kerosene?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Catalyst used in isomerisation process is __________________ ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following does not require preheating during storage in the storage tank as well as during atomisation through burners ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Octane number of n-heptane is assumed to be_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The conductivity of crude oil-water mixture depends on the__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Concentration of H2SO4 catalyst in alkylation is kept between 90-98%, because H2SO4 having concentration?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Cracking is___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Catalyst used in alkylation process is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Good quality kerosene should have__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following fractions of petroleum contains maximum sulphur ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  1 centistoke is equal to ______________ Redwood I seconds?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Higher vapour pressure of gasoline indicates _________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which parameter is used for the grading of paraffin waxes ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is the easiest to crack ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Clay treatment is used to remove ___________________ ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  _____________ chloride present in crude petroleum as impurity is the most prolific producer of HCl during distillation?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Gasoline extracted from natural gas (by compression and cooling) is called the ___________ gasoline?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Catalyst used in the catalytic polymerisation is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm