Production Technology Mcqs

Q.  PERT and CPM are__________________?

a. techniques to determine project status
b. decision making techniques
c. charts which increase aesthetic appearance of rooms
d. aids to determine cost implications of project
e. aids to the decision maker


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The shrinkage allowance for cast iron pattern is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Tandem drawing of wires and tubes is necessary because_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The operation of straightening a curved sheet metal, is known as____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statement is wrong ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following cycles uses air as the refrigerant__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The relative coefficient of performance is_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Clapeyron equation is applicable for registration at___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapor compression cycle, the condition of refrigerant is very wet vapor________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A refrigerant should have _____________________? Pick up the wrong statement ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Clapeyron equation is a relation between___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapor compression cycle, the condition of refrigerant is high pressure saturated liquid________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The boiling point of ammonia is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In S.J. unit, one ton of refrigeration is equal to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Allowable pressure on high-pressure side or ammonia absorption system is of the order of_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The condensing pressure due to the presence of non-condensable gases, as compared to that actually required for condensing temperatures without non-condensable gases ____________________ ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The vapor compression refrigerator employs the following cycle_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The moisture in a refrigerant is removed by___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapor compression cycle the condition off refrigerant is dry saturated vapor________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapour compression cycle, the conditii of refrigerant is saturated liquid________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  An important characteristic of absorption system of refrigeration is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts