|
MCQs: Pick up the correct statement in case of water supply ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Pick up the incorrect statement from the following _______?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Pick up the incorrect statement from the following?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The slope of the outlet of ‘P trap’ below the horizontal is kept________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The expected out turn of half brick partition wall per mason per day is___________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: For 100 sq. m cement concrete (1 : 2: 4) 4 cm thick floor, the quantity of cement required, is_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: For 12 mm thick cement plastering 1 : 6 on 100 sq.m new brick work, the quantity of cement required, is___________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The height of the sink of wash basin above floor level is kept____________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The expected out turn of brick work in cement mortar in foundation and plinth per mason per day, is ________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Pick up the item whose weight is added to the weight of respective item, is________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The ground surface slopes 1 in 50 along a proposed railway embankment 150 m in length. The height of the embankment at zero chainage is 0.5 m, the width is 11 m and side slopes 2:1. If the falling gradient of the embankment is 1 in 150, the quantity of the earthwork calculated by Prismoidal formula, is____________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: S: 1 and length is______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Pick up the correct statement from the following _______?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Pick up the correct statement from the following ________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Pick up the correct statement from the following _________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The load stress of a section can be reduced by______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The maximum ratio of span to depth of a slab simply supported and spanning in one direction, is______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: the column head support a flat slab, is generally kept The diameter of_____________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The floor slab of a building is supported on reinforced cement floor beams. The ratio of the end and intermediate spans is kept______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: In case the factor of safety against sliding is less than 1.5, a portion of slab is constructed downwards at the end of the heel slab, which is known as___________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
