Chemical Engineering Basics Mcqs

Q.  Out of the following, which will fracture most readity, when hit with a hard hammer ?

a. Brass
b. Bronze
c. German silver
d. Cast iron


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  The minimum carbon content in steel should be ____________________ percent for it to respond to a hardening treatment ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which one of the following is incombustible ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As the fluid flow rate increases, the float of the Rotameter____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  High speed steel tools retain their hardness upto a temperature of __________________ °C?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Transformation range for ferrous material is the temperature interval during which ___________________ is formed during its heating?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is not a charge material for cupola ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Sudden fall of atmospheric pressure by a large amount is an indication of the_____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  _____________________ of grey cast iron produces white cast iron?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Stainless steel is welded with difficulty because of____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The softness or hardness of a grinding wheel depends upon the type & amount of bonding material used. For general purpose cutter grinding _______________ grinding wheel is normally used ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  What is the value of entropy at 273°K ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Vernier calipers cannot be used to measure the______________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Powder metallurgy process does not make metal powder by_________________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  With increase in steam pressure, its specific volume decreases ____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Wrought iron is not____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Cast iron contains ____________________ percent carbon?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Transition from laminar to turbulent zone in free convection heat transfer is governed by the critical value of ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following parameters is not responsible for the heat loss from a hot steam carrying bare pipe surface located in a room without fans ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Ammonia leakage in the refrigeration system is detected by_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Blast furnace slag is mainly molten_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts