Thermodynamics Test Questions

Q.  On psychrometric chart, wet bulb temperature lines are

a. horizontal with uniformly spaced
b. horizontal with non-uniformly spaced
c. inclined with uniformly spaced
d. inclined with non-uniformly spaced


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  What is the difference between work done by a system through an ideal reversible process and actual work done by the system called?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which will be a suitable condition of exergy loss and entropy generation for thermodynamically efficient process?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the value of exergy in general?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the dryness fraction (x) on saturated vapour line?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a mixture of ideal gases of volume V and temperature T, what is the pressure exerted by each individual gas if it occupies the total volume V alone at temperature T called?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the entropy change when the system is at stable equilibrium state?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the entropy of the system at equilibrium state?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  As the heat rejection temperature decreases in the vapour power cycle below atmospheric pressure,
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What should be the critical temperature of working fluid for maximum efficiency of vapour power cycle?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The specific heat of the ideal working fluid used in vapor power cycle
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The specific heat of the ideal working fluid used in vapor power cycle
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the importance of the freezing point of the working fluid in the vapour power cycle?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When two vapor cycles are coupled in series and heat rejected by one is absorbed by another, the cycle is called as
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In working condition of turbojet engine, velocity of air entering the engine is
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Why do the airplanes fly at higher altitude during the long flights?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The propulsive efficiency is the ratio of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In turbofan engine, fan is used
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In turbofan engine, the bypass ratio is the ratio of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the effect of increasing bypass ratio of a turbofan engine on its thrust?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Heat pump is used
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts