Basic Mechanical Engineering Test

Q.  On drilling machine, which process is known as reaming?

a. Enlargement of existing hole
b. Hole made by removal of metal along the hole circumference
c. Smoothly finishing and accurately sizing a drilled hole
d. All of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which of the following statements is/are true? 1. Magnification factor is minimum at resonance 2. The maximum value of amplification factor increases as damping factor decreases 3. The maximum value of amplification factor increases as damping factor increases 4. Magnification factor is maximum at resonance
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by geometric modeling?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Simulation is a process which _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Seismometer can be used to measure acceleration of any instrument only if _____
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of monitoring system uses stroboscope to measure speed of the machine?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following conditions is/are to be satisfied by the seismometer for it to be used as velometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following methods can be used to reduce excitation level at the source?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a type of untuned vibration absorber?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which basic document describes general requirements for measurement and evaluation of machine vibrations using shaft measurements?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is not considered when reference standards are used in the field of mechanical vibration and shock, monitoring and analysis of machines?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The noise level generated by domestic air conditioner ranges between _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following construction equipments have highest noise level?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of earplugs contain silicon rubber and a fixing agent?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following absorptive treatment can be used to cover the interior of a box to prevent the reverberant sound?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by Reverberant chamber?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Determine velocity of sound in air at 50o. (For air, γ = 1.4)
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Sound wave has a frequency of 8 kHz at 22o C. Determine its wavelength.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What will be the sound power level, if a machine generates 20 W power?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Secondary force in reciprocating engine mechanism is caused due to _______
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts