Chemical Engineering Basics Mcqs

Q.  Often earing defects are found during deep drawing operation, because the __________________?

a. Surface finish of the sheet is poor
b. Sheet material has been given substantial spring back
c. Starting sheet has planer anisotropy due to its texture
d. Starting sheet has normal anisotropy due to its texture


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Thermal equivalent of electrical power in practical calculation is _______________ kcal/kWh ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  One of the methods of purification of leach liquor is ion exchange, which involves_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The unit of gc is ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Notched bar test is used for testing the _________________ of a material?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A material being tested for endurance strength is subjected to the _______________ load ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The most abundant metal present in the earth’s crust is__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The fugacity of liquid water at 298 K is approximately 3171 Pa. Considering the ideal heat of vaporisation as 43723 J/gm.mole, its fugacity at 300 K would be________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Cold heading or upsetting is categorised as the ________________ process ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which one can be directly solidified from gaseous state without entering into liquid state ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Out of the following, maximum temperature drop for a given heat flow & for the same thickness will be in the case of________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Glass reacts with___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Lead is added to 60:40 brass primarily to improve_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A steam pipe is intended to be insulated with two layers of insulating materials of different thermal conductivities. For minimum heat transfer to take place_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A material subjected ________________ must have high resilience?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  An example of unsteady non uniform flow is the flow of liquid under pressure through a__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Depreciation of machines fails under the indirect expenses head. As per income tax regulations, it is calculated by the __________________ method?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Gas turbine normally employs a constant _______________ cycle?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Surface tension of a liquid_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Boiler draught of 10 mm water column is equivalent to_____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  What is the range of tempering temperature (°C) for most of the materials ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts