MCQs: A simply supported beam deflects by 5 mm when it is subjected to a concentrated load of 10 kN at its centre. What will be deflection in a 1/10 model of the beam if the model is subjected to a 1 kN load at its centre ?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: For a single point load W moving on a symmetrical three hinged parabolic arch of span L, the maximum sagging moment occurs at a distance x from ends. The value of x is__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Sinking of an intermediate support of a continuous beam________________?
Consider the following statements
1. reduces the negative moment at support
2. increases the negative moment at support
3. reduces the positive moment at support
4. increases the positive moment at the centre of span
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: When a load crosses a through type Pratt truss in the direction left to right, the nature of force in any diagonal member in the left half of the span would_______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The deformation of a spring produced by a unit load is called _________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The width of the analogous column in the method of column analogy is _________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Muller Breslau’s principle for obtaining influence lines is applicable to___________________?
i) trusses
ii) statically determinate beams and frames
iii) statically indeterminate structures, the material of which is elastic and follows Hooke’s law
iv) any statically indeterminate structure
The correct answer is ?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Select the correct statement___.?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A load ‘W is moving from left to right support on a simply supported beam of span T. The maximum bending moment at 0.4 1 from the left support is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: In the displacement method of structural analysis, the basic unknowns are__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Which of the following methods of structural analysis is a force method ?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: When a uniformly distributed load, shorter than the span of the girder, moves from left to right, then the conditions for maximum bending moment at a section is that___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The maximum bending moment due to a train of wheel loads on a simply supported girder_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: For a symmetrical two hinged parabolic arch, if one of the supports settles horizontally, then the horizontal thrust__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Bending moment at any section in a conjugate beam gives in the actual beam_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: While using three moments equation, a fixed end of a continuous beam is replaced by an additional span of__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The degree of static indeterminacy up to which column analogy method can be used is__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The carryover factor in a prismatic member whose far end is fixed is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Principle of superposition is applicable when___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The principle of virtual work can be applied to elastic system by considering the virtual work of_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts
